H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 70)

54
Field Description
Serial-ID Serial ID of the AP.
IP Address IP address of the AP.
H/W Version Hardware version of the AP.
S/W Version Software version of the AP.
Boot-Rom version Boot ROM version of the AP.
Description Description of the AP.
Connection Type AP connection type: "Master" or "Backup"
Peer AC MAC Address Peer AC MAC address in case of AC backup.
Priority Level AP connection priority.
Echo Interval(s) Interval for sending echo requests, in seconds.
Statistics report Interval(s) Interval for sending statistics information messages, in seconds.
Cir (Kbps) Committed information rate in kbps.
Cbs (Bytes) Committed burst size in bytes.
Jumboframe Threshold Threshold value of jumbo frames.
Transmitted control packets Number of transmitted control packets.
Received control packets Number of received control packets.
Transmitted data packets Number of transmitted data packets.
Received data packets Number of received data packets.
Configuration Failure Count Count of configuration request message failures.
Last Failure Reason Last configuration request failure reason.
Last Reboot Reason
Last reboot reason of the AP:
• Normal—The AP was powered off.
• Crash—The AP crashed, and the information is needed for analysis.
• Tunnel Initiated—The reset wlan ap command is executed on the AC (in
this case, the Tunnel Down Reason is displayed as Reset AP).
• Tunnel Link Failure—The fit AP rebooted abnormally because an error
occurred when the AP was establishing a connection with the AC.
Latest IP Address IP address of the last AP.
Tunnel Down Reason
The tunnel between the AC and the AP is down when one of the following
occurs:
• Neighbor Dead Timer Expire—The AC does not receive an Echo request
from the AP within three times the handshake interval.
• Response Timer Expire—The AC sends a control packet to the AP but
does not receive any response within the specified waiting time.
• Reset AP—The AP is rebooted by the execution of a command on the AC.
• AP Config Change: The corresponding configurations are modified on
the AC.
• No Reason—Other reasons.