H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 143)

127
The Result box displays the test results.
Figure 103 Loopback test result
Configuration guidelines
When you perform a loopback test, follow these guidelines:
• You can perform an internal loopback test but not an external loopback test on a port that is
physically down, while you can perform neither test on a port that is manually shut down.
• The system does not allow Rate, Duplex, Cable Type, and Port Status configuration on a port under
a loopback test.
• An Ethernet port operates in full duplex mode when the loopback test is performed, and restores its
original duplex mode after the loopback test.