H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 235)

219
Table 84 Configuration items
Item Description
Auto AP
• enable—Enable the auto AP function. You must also select Auto
from the Serial ID list on the AP setup page to use the auto AP
function.
• disable—Disable the auto AP function.
By default, the auto AP function is disabled.
IMPORTANT:
After using the auto AP function, H3C recommends you to disable the
auto AP function.
Renaming an AP
1. After enabling auto AP, click Refresh.
2. To modify the automatically found AP name, click the icon in the Operation column.
Figure 206 Renaming an AP
3. On the page that appears, rename the AP as described in Table 85 .
4. Click Apply.
Table 85 Configuration items
Item Description
Old AP Name Display the name of the automatically discovered AP.
AP Rename Select the AP Rename check box, and type the new AP name.
For the example of configuring auto AP, see "Access service configuration."
Batch switch
If you do not need to modify the automatically found AP names, you can select the AP Name box, and
then click Transmit All AP to complete auto AP setup.