H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 353)

337
Table 111 Configuration items
Item Description
Service status
• enable—Enable IACTP service.
• disable—Disable IACTP service.
IP type Select IPv4 or IPv6.
Source address Source address of the IACTP protocol.
Auth mode
MD5—Select the MD5 authentication mode. This item is optional.
The control message integrity can be verified when the MD5
authentication mode is selected. The sender (an AC) calculates a digest
based on the content of a control message. On receiving such a message,
the receiver (another AC in the roaming group) will calculate the digest
again and compare it against the digest present in the message to verify
the integrity of the packet received. If the digests are the same, the packet
is not tampered.
Auth key
MD5 authentication key.
If you select the MD5 authentication mode, you need to input an
authentication key.
Adding a group member
1. Select Roam > Roam Group from the navigation tree.
Figure 369 Adding a group member
2. Add a group member as described in Table 112 .
3. Click Add.
4. Click Apply.
Table 112 Configuration items
Item Description
IP address
Add the IP address of an AC to a roaming group.
IMPORTANT:
When you configure a roaming group, the roaming group name configured
for the ACs in the same roaming group must be the same.