H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 563)

547
Item Description
Mode
Set a rate limiting mode:
• Static—Limits the rate of each client to a fixed value.
• Dynamic—Limits the total rate of all clients to a fixed value.
Rate
Set the rate of the clients.
• If you select the static mode, Per-Client Rate is displayed, and the rate is the rate
of each client.
• If you select the dynamic mode, Total Rate is displayed, and the rate is the total
rate of all clients.
Setting radio-based client rate limiting
You can configure the access controller to limit client rates for a radio.
To set radio-based client rate limiting:
1. Select QoS > Wireless QoS from the navigation tree on the left.
2. Click the Client Rate Limit tab.
3. Click Add in the Radio-Based Configuration area to enter the page for setting radio-based client
rate limiting, as shown in
Figure 573 .
Figure 574 Setting radio-based client rate limiting
4. Configure radio-based client rate limiting, as described in Table 189 .
5. Click Apply.