H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 617)

601
• Assume Client 3 wants to associate with AP 1. Because the maximum traffic threshold and traffic
gap have been reached on radio 2 of AP 1, Client 3 is associated with AP 2.
Wireless location configuration example
Network requirements
As shown in Figure 639 , AP 1, AP 2, and AP 3 operate in monitor mode, and send the collected tag and
MU messages to an AE (the location server), which performs location calculation and then sends the
data to the graphics software. You can get the location information of the rogue AP, APs, and clients by
maps, forms or reports.
Figure 639 Network diagram
Configuring the AE
1. Configure the IP addresses of AP 1, AP 2, and AP 3 on the AE, or select broadcast for the AE to
discover APs.
2. Perform configuration related to wireless location on the AE.
Configuring AP 1 to operate in monitor mode
AP 1, AP 2, and AP 3 are configured similarly, and the following only describes how to configure AP 1
for illustration.
1. Select AP > AP Setup from the navigation tree.
2. Click Add.
3. On the page that appears, enter the AP name ap1, select the model WA2620-AGN, select manual
from the Serial ID list, enter the AP serial ID in the field, and click Apply.
Switch
AP 2
AP 1
AP 3
Client
Rogue AP
AP
AE (location server)
AC