H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 524)

508
Item Description
Port
To Port
Destination
Operator
Port
Port
Time Range Select the time range during which the rule takes effect.
Configuring line rate
Line rate uses token buckets to control traffic. The line rate of a physical interface specifies the maximum
rate for forwarding packets (including critical packets). Line rate can limit all the packets passing a
physical interface.
To configure line rate:
1. Select QoS > Line rate from the navigation tree.
2. Click the Setup tab to enter the line rate configuration page, as shown in Figure 540 .
Figure 540 Configuring line rate on a port
3. Configure line rate, as described in Table 171 .
4. Click Apply.