H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 107)

91
Item Description
TCP MSS
Set the maximum segment size (MSS) for IP packets on the interface.
The TCP MSS value affects fragmentation and reassembly of IP packets.
IMPORTANT:
Support for this configuration item depends on the interface type. All Layer 3 interfaces
support MTU.
IP Config
Set the way for the interface to obtain an IP address, include:
• None—Select this option if you do not want to assign an IP address for the
interface.
• Static Address—Select the option to manually assign an IP address and mask for
the interface. If this option is selected, you must set the IP Address and Mask
fields.
• DHCP—Select the option for the interface to obtain an IP address through DHCP
automatically.
• BOOTP—Select the option for the interface to obtain an IP address through
BOOTP automatically.
• PPP Negotiate—Select the option for the interface to obtain an IP address
through PPP negotiation.
• Unnumbered—Select this option to borrow the IP address of another interface on
the same device for the interface. If this option is selected, you must select the
interface whose IP address you want to borrow in the Unnumbered Interfaces list.
IMPORTANT:
Support for the way of obtaining an IP address depends on the interface type.
IP Address/Mask
After selecting the Static Address option for the IP Config configuration item, you
need to set the primary IP address and mask, and secondary IP addresses and
masks for the interface.
IMPORTANT:
• The primary and secondary IP addresses cannot be 0.0.0.0.
• For a loopback interface, the mask is fixed to 32 bits and is not configurable.
• The number of secondary IP addresses supported by the device depends on the
device model..
Secondary IP
Address/Mask
Unnumbered Interface
If the Unnumbered option is selected as the way for the interface to obtain an IP
address, you must set the interface whose IP address is to be borrowed.
IPv6 Config
Set the way for the interface to obtain an IPv6 link-local address, include.
• None—Select this option if you do not want to assign an IPv6 link-local address
to the interface.
• Auto—Select this option for the system to automatically assign an IPv6 link-local
address to the interface.
• Manual—Select this option to manually assign an IPv6 link-local address to the
interface. If this option is selected, you must set the IPv6 Link Local Address field.
IPv6 Link Local Address
If the Manual option is selected as the way for the interface to obtain an IPv6
link-local address, you must set an IPv6 link-local address for the interface.