H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 181)

165
Item Description
Mask
Enter the mask of the destination IP address.
You can enter a mask length or a mask in dotted decimal
notation.
Preference
Set a preference value for the static route. The smaller the
number, the higher the preference.
For example, specifying the same preference for multiple static
routes to the same destination enables load sharing on the routes,
while specifying different preferences enables route backup.
Next Hop Enter the next hop IP address, in dotted decimal notation.
Interface
Select the outgoing interface.
You can select any available Layer 3 interface, for example, a
virtual interface, of the device. If you select NULL 0, the
destination IP address is unreachable.
Displaying the IPv6 active route table
Select Network > IPv6 Routing from the navigation tree to enter the page shown in Figure 147 .
Figure 147 IPv6 active route table
Table 68 Field description
Field Description
Destination IP Address
Destination IP address and prefix length of the IPv6 route.
Prefix Length
Protocol Protocol that discovered the IPv6 route.
Preference
Preference value for the IPv6 route.
The smaller the number, the higher the preference.
Next Hop Next hop IP address of the IPv6 route.
Interface
Outgoing interface of the IPv6 route. Packets destined for the
specified network segment will be sent out the interface.