Trace route operation – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 227

211

Figure 198 IPv6 ping operation results

Trace route operation

NOTE:
•

The web interface does not support trace route on IPv6 addresses.

•

Before performing the trace route operations, execute the ip ttl-expires enable command on the
intermediate device to enable the sending of ICMP timeout packets and the ip unreachables enable

command on the destination device to enable the sending of ICMP destination unreachable packets.

Select Diagnostic Tools > Trace Route from the navigation tree.

Click the Trace Route tab to enter the Trace Route configuration page, as shown in

Figure 199

This manual is related to the following products:

H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module