H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 612)

596
Figure 632 Setting traffic-mode load balancing
Verifying the configuration
Client 1 and Client 2 are associated with AP 1. Add Client 3 to the network. When the maximum traffic
threshold and traffic gap are reached on AP 1, Client 3 is associated with AP 2.
Configuration guidelines
An AP starts traffic-mode load balancing only when both the maximum traffic threshold and maximum
traffic gap are reached.
Group-based session-mode load balancing configuration
example
Network requirements
• As shown in Figure 633 , all APs operate in 802.11g mode. Client 1 is associated with AP 1. Client
2 through Client 6 are associated with AP 2, and no client is associated with AP 3.
• Configure session-mode load balancing on the AC. The maximum number of sessions is 5 and the
maximum session gap is 4.
• Session-mode load balancing is required on only radio 2 of AP 1 and radio 2 of AP 2. Therefore,
add them into a load balancing group.