H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 516)

500
Item Description
Rule ID
Select the Rule ID option and enter a number for the rule.
If you do not specify the rule number, the system will assign
one automatically.
IMPORTANT:
If the rule number you specify already exists, the following
operations modify the configuration of the rule.
Action
Select the action to be performed for IPv4 packets matching
the rule.
• Permit—Allows matched packets to pass.
• Deny—Drops matched packets.
Non-First Fragments Only
Select this option to apply the rule to only non-first fragments.
If you do no select this option, the rule applies to all fragments
and non-fragments.
Logging
Select this option to keep a log of matched IPv4 packets.
A log entry contains the ACL rule number, operation for the
matched packets, protocol that IP carries, source/destination
address, source/destination port number, and number of
matched packets.
IP Address Filter
Source IP Address
Select the Source IP Address option and enter a source IPv4
address and source wildcard, in dotted decimal notation.
Source Wildcard
Destination IP Address
Select the Source IP Address option and enter a source IP
address and source wildcard, in dotted decimal notation.
Destination Wildcard
Protocol
Select the protocol to be carried by IP.
If you select 1 ICMP, you can configure the ICMP message
type and code; if you select 6 TCP or 17 UDP, you can
configure the TCP or UDP specific items.
ICMP Type
ICMP Message
Specify the ICMP message type and code.
These items are available only when you select 1 ICMP from
the Protocol list.
If you select Other from the ICMP Message list, you must enter
values in the ICMP Type and ICMP Code fields. Otherwise, the
two fields will take the default values, which cannot be
changed.
ICMP Type
ICMP Code