Configuring ac 1 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 628
612
the ACs perform portal authentication through the IMC server. Configure stateful failover on AC 1 and
AC 2 so that when one AC fails, the other AC can take over portal and other services.
Figure 656 Network diagram
NOTE:
The portal group configuration on the two ACs must be consistent.
Configuring AC 1
1.
Configure the backup AC and enable fast backup:
a.
Select Advanced > AC Backup from the navigation tree to enter the default Setup page, as
shown in
.
b.
Select the IPv4 box and type the IP address of AC 2 (8.190.1.61) as the backup AC address,
and select enable from the Fast Backup Mode list.
c.
Click Apply.
This manual is related to the following products: