Auto, Enabling radio, Configuring a peer mac address – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 338

322

Auto

Set the working channel mode on the MPP and MAP to auto so that the working channel is automatically

negotiated when a WDS link is established between the MPP and MAP.

NOTE:

If you configure the working channel mode of the radios of the MPP and MAP as auto, the automatically
selected working channel is a non-radar channel.

Enabling radio

Select Radio > Radio from the navigation tree to enter the radio setup page.

Figure 344 Enabling radio

Select the radio mode to be enabled.

Click Enable.

Configuring a peer MAC address

Select Wireless Service > Mesh Service from the navigation tree.

Click

to enter the page for binding an AP radio to a mesh service.

Select the AP radio to be bound, and click the

icon to enter the page for configuring a peer

MAC address.

This manual is related to the following products:

H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module