Verifying the configuration, Configuration guidelines, Figure 563 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 550: Selec
534
Figure 563 Applying the QoS policy in the inbound direction of WLAN service service1
Verifying the configuration
After you complete these configurations, the QoS policy is successfully applied to the wireless service
named service1, and the wireless clients cannot access the FTP server at IP address 10.1.1.1/24 from
8:00 to 18:00 every day, but they can do that at any other time.
Configuration guidelines
When you configure an ACL and QoS, follow these guidelines:
•
You cannot add a ACL rule with, or modify a rule to have, the same permit/deny statement as an
existing rule in the ACL.
•
You can only modify the existing rules of an ACL that uses the match order of config. When
modifying a rule of such an ACL, you may choose to change just some of the settings, in which case
the other settings remain the same.
•
When you configure line rate and traffic policing for a behavior, make sure the ratio of CBS to CIR
is more than 100:16. Otherwise, the handling for bursty traffic may be affected.
•
If an ACL is referenced by a QoS policy for defining traffic classification rules, the operation of the
QoS policy varies by interface (the definition of software/hardware interface varies with device
models). The specific process is as follows:
If the QoS policy is applied to a software interface and the referenced ACL rule is a deny
clause, the ACL rule does not take effect and packets go to the next classification rule.
If the QoS policy is applied to a hardware interface, packets matching the referenced ACL rule
are organized as a class and the behavior defined in the QoS policy applies to the class
regardless of whether the referenced ACL rule is a deny or permit clause.
•
If a QoS policy is applied in the outbound direction of a port, the QoS policy cannot influence local
packets. Local packets refer to the important protocol packets that maintain the normal operation of
the device. QoS must not process such packets to avoid packet drop. Commonly used local packets
are: link maintenance packets, ISIS packets, OSPF packets, RIP packets, BGP packets, LDP packets,
RSVP packets, and SSH packets and so on.
•
When you configure queuing for a traffic behavior: