H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 122)

106
Item Description
Access Level
Set the access level for a user. Users of different levels can perform different operations.
Web user levels, from low to high, are visitor, monitor, configure, and management.
• Visitor—Users of visitor level can perform the ping and traceroute operations, but they
can neither access the device data nor configure the device.
• Monitor—Users of this level can only access the device data but cannot configure the
device.
• Configure—Users of this level can access data on the device and configure the
device, but they cannot upgrade the host software, add/delete/modify users, or back
up/restore the application file.
• Management—Users of this level can perform any operations on the device.
Password Set the password for a user.
Confirm Password
Enter the same password again. Otherwise, the system prompts that the two passwords
enter are not consistent when you apply the configuration.
Service Type
Set the service type, including Web, FTP, and Telnet services. You must select one of
them.
Setting the super password
In this part, users of the management level can specify the password for a lower-level user to switch from
the current access level to the management level. If no such a password is configured, the switchover will
fail.
To set the super password:
1. Select Device > Users from the navigation tree.
2. Click the Super Password tab.
The super password configuration page appears.
Figure 78 Super password
3. Set the super password as described in Table 45 .
4. Click Apply.