Configuring ac 1 and ac 2, N in, Figure 377 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 359

343

Figure 377 Network diagram

Configuring AC 1 and AC 2

NOTE:

If remote authentication is required in the authentication mode you select, configure the RADIUS server.
For how to configure the RADIUS server, see "AAA configuration."

Establish AC-AP connections:
Configure AC 1 and AC 2 so that a connection can be established between AP 1 and AC 1, and
between AP 2 and AC 2. Only after the connections are established can you see that the two APs

are in the running status. To view the AP status, select Summary > AP or AP > AP Setup.
For the related configuration, see "Access service configuration."

NOTE:

For the configuration of authentication mode, see "Access service configuration." Fast roaming
supporting key caching can be implemented only when RSN+802.1X authentication is adopted.

Configure a roaming group:

Select Roam > Roam Group from the navigation tree.

On the page that appears, select enable from the Service status list, select IPv4 from the IP Type
list, enter 192.168.1.100 for Source address, the IP address of AC 1, enter the IP address of

AC 2 in the member list, and click Add.

Click Apply.

This manual is related to the following products:

H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module