Configuring the ac, Mesh point-to-multipoint configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 347: Configuration considerations, Figure 359, All r

331

Set the value of maximum links that an MP can form in a mesh network (the default value is 2.).

For more information, see "

Configuring a mesh policy

Figure 359 Network diagram

Configuring the AC

Subway mesh configuration differs from normal WLAN mesh configuration in the mesh policy

configuration of rail APs and train APs. Other configurations are the same. For more information, see

Configuring the AC

Mesh point-to-multipoint configuration example

Network requirements

AP 1 operates as an MPP to establish a mesh link with AP 2, AP 3, AP 4, and AP 5 respectively.
The mesh configuration is the same as the normal WLAN mesh configuration.

Figure 360 Network diagram

Configuration considerations

•

Configure a peer MAC address for each radio interface. Configure the MAC addresses of AP 2

through AP 5 on AP 1, and configure the MAC address of AP 1 on AP 2 through AP 5.

AP 1

AP 2

AP 3

AP 4

AP 5

This manual is related to the following products:

H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module