H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 71)

55
Field Description
Connection Count
Connection count between the AP and AC. This field is reset in one of the
following situations:
• AC is rebooted.
• You re-configure an AP template after deleting the old one.
If you click Reboot on this page to reboot the AP, the connection count will
not be reset.
AP Mode Mode supported by the AP. Currently only the split MAC mode is supported.
AP operation mode
Operation mode of AP. Currently Normal and Monitor modes are
supported.
Portal Service Whether the portal service is enabled or not.
Device Detection Whether device detection is enabled or not.
Maximum Number of Radios Maximum number of radios supported by the AP.
Current Number of Radios Number of radios in use on the AP.
Client Keep-alive Interval
Interval to detect clients segregated from the system due to various reasons
such as power failure or crash, and disconnect them from the AP.
Client Idle Interval(s)
If the client is idle for more than the specified interval, that is, if the AP does
not receive any data from the client within the specified interval, the client
will be removed from the network.
Broadcast-probe Reply Status Whether the AP is enabled to respond to broadcast probe requests or not.
Basic BSSID MAC address of the AP.
Current BSS Count Number of BSSs connected with the AP.
Running Clients Count Number of clients currently running.
Wireless Mode Wireless mode: 802.11a, 802.11b, or 802.11g.
Client Dot11n-only
• Enabled—Only 802.11n clients can be associated with the AP.
• Disabled—802.11a/b/g/n clients can be associated with the AP.
Channel Band-width Channel bandwidth, 20 MHz or 40 MHz.
Secondary channel offset
Secondary channel information for 802.11n radio mode:
• SCA (Second Channel Above)—The AP operates in 40 MHz bandwidth
mode, and the secondary channel is above the primary channel.
• SCB (Second Channel Below)—The AP operates in 40 MHz bandwidth
mode, and the secondary channel is below the primary channel.
• SCN—The AP operates in 20 MHz bandwidth mode.