Keri Systems Doors.NET Manual - Manual (Page 557)

Doors.NET Reference Manual
- 557 -
5. Select the card reader door to be changed. Note that only 1 reader can be selected
for each action type.
6. From the Action Item Properties select the Mode to set the reader to (Card+PIN)
then click save.
7. A second procedure must now be added that will set the reader back to Card Only.
8. Click on Add Procedure. Rename the procedure Reader Mode - Card Only and
repeat the process for creating the previous procedure - (Except select Card Or
PIN for the Mode). Click save and you should now have two procedures defined as
shown below: