Keri Systems Doors.NET Manual - Manual (Page 457)

Doors.NET Reference Manual
- 457 -
Global Unlock Enabled
Enables Global Unlock, placing the Global Unlock icon and the Normal icon into the Situ-
ation Manager field of the ribbon bar. The default is not enabled.
1. To enable Global Unlock, click in the Global Unlock Enabled field in the grid and
select Yes in the pull-down menu.
Global Unlock Ignore Override
When enabled, this option prevents an operator from issuing a manual door command
such as lock door, unlock door, temporary unlock, control point override, or monitor point
override that would countermand the Global Unlock command. If an operator attempts
such a command a message appears stating the command could not be completed and
a corresponding event message is recorded. The default is not to ignore overrides,
allowing an operator to manually operate doors in a Global Unlock state.
1. To ignore manual commands that override a Global Unlock, click in the Global
Unlock Ignore Override field in the grid and select Yes in the pull-down menu.
NOTE: This setting is system wide. If enabled, no manual overrides are allowed regard-
less of hardware settings.
Global Lock Enabled
Enables Global Lock, placing the Global Lock icon and the Normal icon into the Situ-
ation Manager field of the ribbon bar. The default is not enabled.
1. To enable Global Lock, click in the Global Lock Enabled field in the grid and select
Yes in the pull-down menu.