Keri Systems Doors.NET Manual User Manual
Page 262
Doors.NET Reference Manual
- 262 -
There is an 8-pin terminal block on the reverse of the hub for making the wiring con-
nections to the controller.
RS-485 Wiring to NXT Mercury Powered Controller
Wiegand Wiring to NXT Mercury Powered Controller
When connecting to the controller via Wiegand you must have a Reader Interface Mod-
ule (RIM) plugged into the controller’s reader port and it needs to be configured for Wie-
gand (Refer to the RIM Installation guide for setup instructions. The hub is wired into the
8-pin terminal block connected to the RIM.