Keri Systems Doors.NET Manual - Manual (Page 39)

Doors.NET Reference Manual
- 39 -
l
Added firmware upgrade status messages to provide active feedback during an
upgrade.
l
Added options to the System Calendar allowing a Full Cardholder Download and
an Update Network to be scheduled operations.
l
Corrected an issue with setting a vacation date. Vacation Settings are used to tem-
porarily disable a credential when a cardholder goes on vacation. The program ori-
ginally assumed a vacation would start at some date in the future and run some
number of days. If an operator set a credential's vacation date to begin imme-
diately, that start date would not be applied correctly. The program now accepts
immediate vacation start dates.
Known Issues
l
None at this time.
Firmware Requirements
For NXT controllers and peripherals:
l
Standard NXT controllers require new firmware revision 2.05.23.
l
NXT controllers with Mercury Inside firmware require new revision 1.01.40.
l
NXT Readers require current firmware revision 3.01.01.
l
Reader Interface Modules (RIMs) require current firmware revision 3.02.05.
l
4x4 I/O Modules require current firmware revision 3.00.02.
For PXL:
l
PXL controllers require current firmware revision 8.6.04
l
Legacy PXL controllers should be at firmware revision 8.4.49 or greater
(this minimum firmware revision is programmed with the current U.S. Daylight Sav-
ings Time dates)
NOTE: Legacy PXL controllers require an optional license to be used with Doors.NET
software.
For Mercury Inside (MSC) NXT controllers:
l
MSC NXT controllers require new MSC firmware revision 1.01.40.
Firmware Upgrades
Standard NXT Firmware v2.05.23
l
Turns off multicast support within the firmware as the Doors.NET software does not
communicate with the NXT controller via multicast. This allows the NXT controller
to ignore an entire class of Ethernet communication that does not apply to the con-
troller.