Keri Systems Doors.NET Manual - Manual (Page 402)

Doors.NET Reference Manual
- 402 -
9. A cardholder cannot directly be assigned an ‘elevator access group,’ so this group
will need to be added to the general system access groups.
10. From the Home tab click Access Groups.
11. Again click to add a new group. Give it a new description. Select the group. Select
the elevator reader (the reader wired into bus 1), and finally select the elevator
access group.
12. You do NOT need to highlight a time schedule on this page because it has already
been defined in the Elevator Access Group setup page.
13. Click the assign button to finish creating the cardholder’s elevator access group.