Keri Systems Doors.NET Manual - Manual (Page 530)

Doors.NET Reference Manual
- 530 -
Setup Local Linkage
1. After logging into Doors.NET, click the Setup tab, then Local Linkage.
2. The first tab you will see is the procedures tab, but before you can add a new pro-
cedure you will need to select a controller from the controller's drop-down list. The
procedures tab configures the available procedure for each controller. Each pro-
cedure can have multiple actions items assigned to it.
Procedures
The procedures within Doors.NET are anything that the supported hardware is able to
do, think of them as the actions the Mercury hardware is able to perform, either based on
a schedule or from an operator command. It can be one item or a list of items and can
vary from unlocking a door or a group of doors to a complicated mantrap. The software
supports a default of 1,000 trigger conditions and 1,000 procedure action items.
1. Once the controller has been selected you can then click the New Procedure but-
ton to add a new procedure.