Keri Systems Doors.NET Manual - Manual (Page 48)

Doors.NET Reference Manual
- 48 -
l
Adds the ability to change the Server ID, Controller ID, and Network Data using Tel-
net commands. This feature can be useful when configuring Controllers that are
spread out over a WAN.
NXT Reader Firmware v3.01.01
l
Provides support for In-door/Out-door Readers (also known as Master/Slave Read-
ers). This feature allows two Readers to be managed from one bus on the Con-
troller, with both readers controlling one door; one Reader for the In/Entry direction
and one Reader for the Out/Exit direction. A Reader with this firmware revision or
greater can be toggled between In-door and Out-door configurations. This is done
by presenting an NXT Address Change Control Card to the reader within the first
60 seconds of reader power up.
NOTE: Having two Readers of the same configuration on one bus (both In-door or both
Out-door) is an illegal configuration resulting in neither Reader being recognized or
acknowledged by the system.
RIM Firmware v3.02.05
l
Provides support for the Keri NXT-6RK Proximity Reader and Keypad.
l
Provides support for reading 75-bit Wiegand Credentials. In this application the
Expiration Date is stripped from the data bits and just the binary 48-bit credential
value is sent to the Controller.
l
Changes the handling of the * and # keys on Wiegand key pads to support the use
of special commands on NXT controllers using Mercury Inside firmware.
4x4 Firmware v3.00.02
l
Provides complete hardware information when a status command is performed.
Mercury Inside (MSC) Firmware v136
l
Remembers the controller's assigned IP instead of resetting the IP to a default
value whenever the controller is reset.
l
Provides support for In/Out NXT Readers.
l
Provides support for Assa Aperio wireless locks.
Doors.NET Version 3.5.1.12 - SP-2
Doors.NET v3.5.1.12 requires an NXT controller firmware upgrade to v2.05.16 .