Keri Systems Doors16 - Manual (Page 51)

Keri Systems, Inc. Doors™ Users Guide
01821-001 October 1998
Revision 2.1 Page 51
Setup Timezones
Identifies if an operator is allowed to perform the Setup Timezone commands: creating or
editing Timezones and Holiday schedules, or to have Read Only access to review this
information..
Setup Access Groups
Identifies if an operator is allowed to perform the Setup Access Group commands: creating or
editing access groups (specifically associating timezones with doors), or to have Read Only
access to review this information.
Setup Monitor
Identifies if an operator is allowed to modify a Monitor window (a window that views events
on the access control network as they happen), or to have Read Only access to review this
information.
Setup Operators
Identifies if an operator is allowed to create new operators.
Operate Doors
Identifies if an operator is allowed to manually lock and unlock doors using program
commands and to perform complete database updates of selected controllers on the access
control network.
Start Monitor
Identifies if an operator is allowed to start the event monitoring process.
Stop Monitor
Identifies if an operator is allowed to stop the event monitoring process.
Start Monitor #1, #2, #3
Identifies which of the three definable event monitors an operator may open.
Card Reports
Identifies if an operator is allowed to generate Card reports (this feature is not yet available).
Door Reports
Identifies if an operator is allowed to generate Door reports (this feature is not yet available).
Event Reports
Identifies if an operator is allowed to generate Event reports (summaries of events that have
occurred on the access control network).
Exit Program
Identifies if an operator is allowed to exit the Doors program, returning to the operating
system.
NOTE: Exiting the program does not end the access control process. Once all information is
entered and uploaded to all controllers, the controllers manage access by themselves and the
Doors program is only needed for uploading changes to the controllers or downloading event
information from the controllers.
Depending upon the assignment choice, each Operator assignment is set to one of these three
values.