Keri Systems EntraGuard Gold Quick Start User Manual
Gold quick s tart guide, Entraguard, Gold telephone entry controller
EntraGuard
®
Gold Telephone Entry Controller
1530 Old Oakland Road, Suite 100
01801-001 Rev. 2.2
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 1 of 32
EntraGuard
®
– Gold
Quick S
tart Guide
This quick start guide provides, basic installation information, drawings, first time power-on instructions, and short
descriptions of key terms and concepts for installing the EntraGuard Gold Telephone Entry controller. The EntraGuard
Gold controller may be used alone or may be connected to a PXL network.
1
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing
the installation.
Figure 1: The EntraGuard Gold Telephone Entry Controller - Mechanical Keypad Front Panel
1. If the EntraGuard Gold unit is connected to a PXL-250 network, the EntraGuard unit must be the master
controller.
Document Outline
- 1.0 Specifications
- 2.0 Cable Requirements
- 3.0 When Installing Controllers
- 4.0 Wiring Instructions
- 4.1 Terminal Blocks
- 4.2 Connecting the Earth Ground and the 12 VDC Power
- 4.3 Connecting a Door Status Input
- 4.4 Connecting a Request to Exit (RTE) Input
- 4.5 Connecting a General Purpose Input
- 4.6 Connecting an Alarm Output Relay
- 4.7 Connecting a Fail-Safe Lock Output Relay
- 4.8 Connecting a Fail-Secure Lock Output Relay
- 5.0 Communication
- 6.0 Postal Lock Installation
- 7.0 Powering the Controller for the First Time
- 8.0 Setup Controller
- 9.0 General Information on Inputs
- 10.0 General Information on Safety versus Security with Door Locks