Keri Systems EntraGuard Silver Walk-Up Package User Manual
Entraguard, Silver walk-up package, 0 drawings
EntraGuard
®
Silver Walk-Up Package
Quick Start Guide
Page 1 of 12
P/N: 01535-001 Rev. A
This quick start guide provides the basic information needed to mount, install, power up, and program a basic EntraGuard
Silver Walk-Up Package. The Walk-Up Package is made from an EntraGuard Silver Telephone Entry Controller and a
PXL-500G-1 controller in a single container. The Walk-Up Package comes pre-wired from the factory. The EntraGuard
Silver Walk-Up Package may be used as a stand-alone unit or in a PXL/EntraGuard Access Control network. For
additional information refer to the full set of documentation available on the Keri Installation CD or at www.kerisys.com
(instructional training is also available at the website).
All door control functions are controlled by the EntraGuard board. Door contacts (DSM) and Request to Exit
(RTE) are wired to the EntraGuard board. When a credential is presented to the reader (mounted on the front
panel of the Walk-Up unit) and access is granted, the Lock Output relay of the PXL-500G-1 will trigger the RTE of
the EntraGuard board and the EntraGuard board will trigger the EntraGuard Lock Output Relay. The
EntraGuard board will control monitoring of door position and RTE (if DSM and RTE are in use).
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing the
installation.
Section 01 - Drawings
Section 05 - Communication
Section 06 - Powering Up for the First Time
Section 03 - Cable Requirements
Section 07 - Setup Controller
Section 04 - Earth Ground and the 12 VDC Power
Section 08 - Contact Keri Systems
1.0
Drawings
1.1
EntraGuard Silver Walk-Up Package Front Panel
Figure 1: The EntraGuard Silver Telephone Entry Controller - Front Panel