ETC Congo Family v6.4.0 - Manual (Page 941)

939
Key Function Feedback
Select a channel # [SHIFT] [CH] Channel is selected
Add channels # [SHIFT] [THRU] Channels are added to
selection
Select a group # [#] [SHIFT] [CH] Channels in Group # are
selected
Select All [SHIFT] [ALL] Selects all channels with
a level that were set from
the remote
Set to Full [SHIFT] [100%] Levels for the selected
channels are set to full
Set to 0% [SHIFT] [0%] Levels for the selected
channels are set to zero
Set to level # # [SHIFT] [@LEVEL] Level # is set for
selected channels
Check mode [SHIFT] [CHECK+]
[SHIFT] [CHECK-] Steps to the Next/Last
channel using level.
Load levels from Preset
# # [SHIFT] [PRESET] Levels from Preset # are
loaded
Clear number input [#] [#] Clears number input
Decimal point [#] Decimal point
GO [SHIFT] [Goto/Go] Next crossfade is started
Goto preset/step # [SHIFT] [Goto/Go] Crossfades to preset #
or step # (depending on
the GOTO jumps to
setting in Setup)
Record preset # [SHIFT] [Record] Records Preset # into
the Preset List. Only the
levels set from the
remote are recorded
Examples
Turn on channels 2 thru 5 at Full.
[2] [SHIFT] [CH] [5] [SHIFT] [THRU] [SHIFT] [100%]
Using the decimal point it is also possible to select and turn on channels recorded in groups.
To set Group 1 at Full
[1] [#] [SHIFT] [CH] [SHIFT] [100%]