ETC Congo Family v6.4.0 - Manual (Page 568)

566
Device Control - Fetch/Copy
Use Fetch to copy parameter values for devices from any Preset. Fetching from Presets in
the Main Sequence will copy the STATE of those devices including any tracked values from
presets earlier in the Sequence.
First select the devices you wish to copy values to.
Function Key Feedback
FOCUS values [#] [FETCH] &
[FOCUS] Focus values from
Preset # are copied to
the selected channel(s).
COLOR values [#] [FETCH] &
[COLOR] Color values from Preset
# are copied to the
selected channel(s).
BEAM values [#] [FETCH] &
[BEAM] Beam values from
Preset # are copied to
the selected channel(s).
Parameter values [#] [FETCH] &
[Wheel_Key] Parameter values from
Preset # are copied to
the selected channel(s).
All values [#] [FETCH] &
[ATTRIB] All parameter values
from Preset # are copied
to the selected
channel(s).
NOTE
If the Preset specified is in the Main Sequence, you will fetch the
ACTUAL STATE of the attributes in the specified preset. This is not
necessarily the same values that are stored in that preset, since
some of them may be tracking into it from previous presets.
HINT
You can fetch intensity values as well. See
Presets - Fetch Intensities .