ETC Congo Family v6.4.0 - Manual (Page 612)

610
Device Times - Introduction
A Moving Device can have Times and Delays in the following ways.
• No time - follows the Sequence Step In-time.
• Parameter group times - an attribute time for FOCUS, COLOR or BEAM
parameters.
• FCB times - Same as above, but there is a shortcut for setting all three
• Device parameter times - A time for each attribute of a Moving Device.
NOTE
All times are set to the Preset in the A or B field depending on the
setting of the parameter "
Set Times To Field " in the Congo Settings.
All attribute times are stored with a Preset.
There is a default Attribute Time that is used when Moving Devices are positioned manually
or with GoInB. See
Moving Device Times - Default Attribute Time .
Default Attribute Time (6.2)
The Default Attribute Time (3 seconds) is used mainly to keep noise and unnecessary
mechanical friction down when a Moving Device is positioned in the following situations:
• When attributes are executed from Independents
• When copying Blind attributes to Live
• When using Stop table for an old dynamic
• When you press Home Attributes
• When jumping in the sequence
• Using REFRESH in the Main Playback
To change this time see Attribute Settings .
NOTE
The Default Attribute Time does not affect how fast a palette is
activated from direct selects or directly. This time can be set on the
fly - for example #(s) DIRECT SELECT PALETTE.
See Shortcuts - Device Palette Activating