ETC Congo Family v6.4.0 - Manual (Page 512)

510
Track - Track Editing
Track editing is a very powerful way to edit in a Sequence. They are used to save time when
the same type of change is wanted in a series of Presets.
Track Editing - Intensities
Intensity changes in a Preset (for all channels) can be tracked forward and/or backward.
When an Intensity Block is set they will stop. This can be set in the Sequence List. See
Sequences - Block Values .
1. Make level changes in a Preset
2. Hold UPDATE and press @LEVEL. A track popup will open.
3. Select forward, backward or both.
4. Confirm.
NOTE
Each channel will be tracked individually until the position where the
level changes value. Dialog shows the number of channels that will
be affected. A step in the sequence set to Block Tracking will prevent
levels from tracking through. To set a block on individual channels in
a step – set the intensity to 1% higher or lower on those channels
you wish to block.