ETC Congo Family v6.4.0 - Manual (Page 137)

135
Freeze Mode
When the Output Mode switch is set to FREEZE, the output is "frozen" and will remain static
until the switch is set back to ON.
When the switch is set back to ON the output is loaded to the A field of the Main Playback.
The Sequence will also reposition to where it was when you activated Freeze.
Action Feedback
Activate Freeze All outputs will be "frozen", including moving
devices. You can work with all functions without
affecting the output*
Deactivate Freeze The "frozen" output of Freeze is loaded to the A
field of the Main Playback**
*The complete output, including all Master Playbacks is loaded to Freeze.
**If all Masters are down when you exit Freeze, there is no change in the output on stage.
NOTE
If you set the Output mode switch to FREEZE before you start the
application, the output will not be updated until you move the switch
to on. This makes it possible to start without output and prepare the
correct light before activating it on stage.
This is indicated at the top of the screens with the text "FREEZE".