ETC Congo Family v6.4.0 - Manual (Page 235)

233
Attribute Settings (6.0)
The Attribute settings affect recording and control of moving device parameters.
Recording and control functions
Function Explanation Default
Sequence attribute
playback default Record attributes to move "live"
(GoOnGo), when the positions
are loaded for the next
Crossfade (GoInB) or Auto
Move. Auto Mark*
Record Attribute mode There are different modes for
recording Attributes. See
Device
Recording - Modes . See Attrib
Move in Sequence List -
Functions .
Active
Attribute Editor default The default setting for entering
values in the Attribute Editors:
Palettes or %. Palette
Default Attribute time Sets a time for all moving device
changes during programming. 3 seconds
Time: Use % as default Times are set as % of the In-
time of a crossfade, or in
seconds. Off (seconds)
Coarse/Fine 16 bit
control When checked, holding down
the Wheel Key gives 'fine'
control on the parameter wheel.
When unchecked, moving the
wheels slowly gives fine control.
See
Device Templates - 16 bit
control .
Off (8 bits)
Override scroller fan
value Override the fan of all patched
scrollers with fan control. 0%
Sort devices by type
(6.0) Specifies if attribute views
should be sorted by channel
number or by device type Off
*You can change this separately for each Sequence Step in the Sequences - Sequence
List .