ETC Congo Family v6.4.0 - Manual (Page 249)

247
A message is shown in the Message area (bottom of screens) on the Server system when
a Backup or Client is started. The system that is started as Backup now displays an
information message about this.
When the contact is lost between two linked Congos a message is shown in the Message
area (bottom of screens), and the Backup Congo is automatically converted to Server.
ETCNet2
You can connect to ETC nodes with a Switch (avoid routers, they tend to complicate things).
Congo consoles/Client PCs should be given IP addresses in the 10.101.201.101+ range
when used with ETCNet2. Please see the ETCNet2 v4 Planning Guide for information on
configuring an ETCNet2 network.
Network - Backup Setup
A system can be set up to start as Backup or Server regardless of the order in which the
systems are powered, or by detecting this order. There is also a setting for Auto-transferring
the current play to the Backup when both systems are powered up.
These settings are in the System Settings of the Welcome Screen .
1. Exit to the system settings if Congo is running (Browser >File node).
2. Open System Settings
3. Select Backup Setup at the bottom.