ETC Congo Family v6.4.0 - Manual (Page 238)

236
Standard MIDI (6.4)
All keys and faders can send notes and controllers when this is activated in the MIDI
Settings.You can use MIDI notes and controllers to remote control any key or fader of the
Console.The Congo can also be set to activate a specific crossfade when receiving a
Program Change command through MIDI. See
MIDI .
Function Explanation Default
value
Direct mode Midi Direct Mode (6.4) On
MIDI Channel The MIDI channel used by
Congo 1
Keys All keys are sent as notes. Off
Faders All faders are sent as controllers. Off
Program Change Jumps to sequence step # -
MIDI Show control
Congo supports sending and receiving of MIDI Show Control (MSC) commands. See MIDI -
MIDI Show Control .
Function Explanation Default
value
Enable Activates reception of MSC. Off
Device ID Sets a Device ID for this Congo. 1
Time Code
Every sequence step can be triggered both manually, and by a specific MIDI Time Code time
on the MIDI port. See
MIDI - Time Code .
Function Explanation Default
value
Time Code MIDI Times Code reception is
on. Off
Learn mode Activate learn mode for setting
Time Code to Sequence Steps. Off
Auto-locate step Sets if Time Code should auto-
locate steps or not. Off
Enable Backup clock Enables the backup clock Off
Internal clock start Sets a start time for the internal
clock. --.--.--.--