ETC Congo Family v6.4.0 - Manual (Page 562)

560
Control Soft Key Page - Functions
Action Soft Key Feedback
Enable [ENABLE] This key has to be
pressed together with
Lamp On/Off/Reset to
activate them (as a
safety measure).
Lamp Idle [ENABLE] &
[Lamp_Idle] The Device is set to it's
Lamp idle value
Lamp On [ENABLE] &
[Lamp_On] A lamp strike is set to the
selected channel(s)
Lamp Off [ENABLE] &
[Lamp_Off] A lamp off is set to the
selected channel(s)
Reset [ENABLE] & [Reset] A lamp reset is set to the
selected channel(s)
NOTE
These functions are Device and Template Specific. Check the manual
and template of each Device.
Control parameters are not stored in Presets.
Press HOME ATTRIB after a Lamp On/Off/Reset, or lamp idle, to avoid
sending control commands to the lights forever.