ETC Congo Family v6.4.0 - Manual (Page 402)

400
Sequence Times - Main Times (in/out/delay/wait)
Times are set to the step in A (Active) or B (Next) depending on the setting for times (SETUP
& TIME).
Function Key Feedback
In time [#] [IN] A time is set for the
incoming channels.
Out time [#] [OUT] A time is set for the
outgoing channels.
In- and Out time [#] [TIME] A time is set for the in-
and outgoing channels.
Delay In time [#] [DELAY] & [IN] A delay time is set for
the incoming channels.
Delay Out time [#] [DELAY] &
[OUT] A delay time is set for
the outgoing channels.
Wait, Followon or
Alert time * Sequences -
Sequence List Enter the time in the
WFA Time column of the
Sequence List. You can
toggle between Wait,
Alert or Followon in the
previous column
* A Wait or Followon time will automatically execute a crossfade to the Step it is assigned to.
The difference is that a Wait time starts counting down after the END of the previous
crossfade, while the Followon time starts counting down from the START of the previous
crossfade. Wait times is the default setting. The Alert time will count down as a warning to
the operator, but not execute the next fade. See
Sequence Times - Alert Times .
See Times Soft Key Page .
You can view/edit the main times in the Sequence List .