ETC Congo Family v6.4.0 - Manual (Page 365)

363
Record Preset - Do not add to Sequence
When a Preset is recorded, it is automatically added to the sequence in the Main Playback. It
is possible to bypass this.
Action Key Feedback
Record
selected to
Preset # [#] [RECORD]
& [PRESET] The Preset is recorded and added to the
Preset List, but not to the Sequence in
the Main Playback.
Record All Attributes for selected channels
Depending on how attribute recording is set up only changed moving device parameters are
recorded. You can record all parameters of the selected channels at any time with a
shortcut (similar to a block cue). See
Device Recording - Introduction .
Setting Key Feedback
Record selected [RECORD] &
[ATTRIBUTES] Record all attributes for
the selected channels to
the currently loaded
Preset in the A field.
You will get a popup, see
below.
Record selected to... [#] [RECORD] &
[ATTRIBUTES] Record all attributes for
the selected channels to
Preset #.
You will get a popup, see
below.
This is the Record Attributes popup
NOTE
Control parameters are normally not recorded. However, many
fixtures have control on the Strobe parameter, which is recorded.