ETC Congo Family v6.4.0 - Manual (Page 622)

620
Device Play back - Attributes Follow Faders
Attributes will follow the manual movement of masters depending on the Master Settings.
These are some general rules. See
Master Settings .
The always follow the B fader of the Main Playback.
• They start moving at 1%.
• Snap parameters also trig at 1%.
Master Playbacks behave different from the crossfaders of the Main Playback.
Masters And Attributes - General
When a master leaves its 0% position, the corresponding attribute parameters are trigged
and follow the fader.
During a timed fade in a Master, attributes will follow the FCB-times of the Preset in that
Master.
If another master with overlapping attribute parameters is activated, (leaves 0%), it will take
control of the corresponding attributes. To re-gain control from any Master, move it to 0%
and up again.
How attributes behave when moving the Master fader down depends on the settings for the
fader.
Crossfaders And Attributes
When a manual crossfade is made, the attribute positions will follow the B fader. If the fader
is moved slower than the time assigned to the attributes, the fader has control. If the fader is
moved faster than the assigned time, the time will take control to make a smooth movement.
N/A
N/A