ETC Congo Family v6.4.0 - Manual (Page 203)

201
fetched from the setting above. In Offline mode, Streaming ACN is sent on priority 1.
Visualisation software such as Capture require sACN tor CITP.
ETCNet2
Activate if you are using any ETCNet2 nodes. The system name that is exposed on Net2 is
“Congo “ + the system name.
• ETCNet2
Priority: An ETCNet2 source can have a priority of 20-1. 1 is highest, and 20 is
lowest. This parameter decides the priority status of this system if there are multiple
sources (for example Congo and Unison). Sources with the same priority share on
an HTP level. If there are different priorities, the highest one will "win". See ETCNet2
documentation.
• Server/Backup Use Same Priority
This setting inhibits the Congo Backup unit from activating at a higher priority than
the server. Normally, the backup will activate at a higher priority to ensure that the
system is being controlled by only one server. In some systems, however, control is
shared by the Congo server and other consoles or architectural lighting control in
such a way that having the backup jump a priority can cause unexpected behavior of
the system. In those systems, it may be desired to force the backup to activate at the
same priority as the server.
Other
Two other common third party protocols are ArtNet and AvabIPX.
• ArtNet
- Check this feature if you are using devices or nodes receiving ArtNet.
Address: Choose network and IP address if more than one is available.
• Avab IPX
- Check this feature if you are using devices or nodes receiving AVAB IPX. The
settings of the Logical Network will affect the AvabIPX settings. Visualisation
software such as WYSIWYG require Avab IPX to be ON.
UNIVERSE MAP
Opens the universe map tab.