ETC Congo Family v6.4.0 - Manual (Page 409)

407
Sequence Times - WAF Alert Times
An Alert time will count down from the completion of the previous crossfade, and alert the
operator as to when the next fade should be manually executed.
There is a Learn Mode that will record Alert times automatically as a show is played back in
real time by an operator. This mode is activated with the soft key LEARN ALERT in the
Times Soft Key page. See
The Times Soft Key Page .
Time Limit
There is both a visual and an audio warning set to alert 5 seconds before the next fade. You
can change this time limit in the Time Settings. See
Settings - Crossfade .
Visual
The top part of the playback view will be green as long as the alert time is over 5 seconds. At
5 seconds it turns yellow and after completion it turns red.
The Alert time is edited in the Sequence List WFA and WFA Time columns. It can be toggled
to be a Wait or Followon Time as well. See
Sequence List - Columns . See also Sequence
Times - WFA Wait & Followon Times .
Sequence Times - WAF Wait & Followon Times
It's possible to set a Wait or Followon time between each step of a Sequence.
Wait
A Wait time will execute the step it is on, # seconds after the completion of the previous fade.
Followon
A Followon time will execute the next step, # seconds after the start of the fade. The
Followon time is displayed in the same way as the Alert Times. See
Sequence Times - WAF
Alert Times .
The Wait and Followon times are edited in the Sequence List WAF and WAF Time columns.
They can be toggled to be an Alert Time as well. See
Sequence List - Columns .