Schneider Electric Processor Adapter - Manual (Page 371)

Configuring a Modbus Plus Network in Concept with Peer Cop
870 USE 101 10 V.2 371
Accessing the Peer Cop Dialog Box
Introduction This section describes how to access the Peer Cop dialog box in Concept 2.1.
Accessing the
Screen Follow the steps below to access the Peer Cop from the PLC Configuration Screen.
Continued on next page
Note: The 171 CCC 960 30 and 171 CCC 980 30 require Concept 2.2 with
service release 2.
Step Action
1 Check the status of Peer Cop.
l If Peer Cop is enabled, jump to step 4.
l If Peer Cop is disabled, continue with step 2.
Example: The Peer Cop status is reported in the Configuration Extensions
section of the PLC Configuration Screen. Here Peer Cop is disabled:
2 Double-click on the Peer Cop field.
Result: The Configuration Extension dialog box appears.