13 parameter / command / drive data set – Siemens 440 User Manual

Page 97

Issue 01/06

Parameter Description

MICROMASTER 440 Parameter List
6SE6400-5BB00-0BP0

3.13

Parameter / command / drive data set

P0800[3]

BI: Download parameter set 0

Min: 0:0

CStat:

Datatype: U32 Unit:

Def:

0:0

P-Group: COMMANDS

Active: first confirm

QuickComm.: No

Max: 4000:0

Defines source of command to start download of parameter set 0 from attached AOP.

Index:

P0800[0] : 1st. Command data set (CDS)
P0800[1] : 2nd. Command data set (CDS)
P0800[2] : 3rd. Command data set (CDS)

Common Settings:

722.0 = Digital input 1 (requires P0701 to be set to 99, BICO)
722.1 = Digital input 2 (requires P0702 to be set to 99, BICO)
722.2 = Digital input 3 (requires P0703 to be set to 99, BICO)
722.3 = Digital input 4 (requires P0704 to be set to 99, BICO)
722.4 = Digital input 5 (requires P0705 to be set to 99, BICO)
722.5 = Digital input 6 (requires P0706 to be set to 99, BICO)

Dependency:

1. The parameter set 0 can only be downloaded in conjunction with the AOP
2. Establish communications between the frequency inverter and AOP
3. The frequency inverter must be selected using the AOP if the AOP is connected at the COM link

interface (RS485)

4. Select the frequency inverter state "Ready" (r0002 = 1)
5. Signal from P0800:

0 = Do not download.

1 = Start to download parameter set 0 from the AOP.

(0:0)

BI: Dwnl .par.set 0

P0800.C

Inverter

r0002 = 1
"Drive ready"

BOP link

COM link

AOP

Parameter set 0
Parameter set 1

Parameter set 9

...

Transmission of "Parameter set 0" from AOP to inverter

P0801[3]

BI: Download parameter set 1

Min: 0:0

CStat:

Datatype: U32 Unit:

Def:

0:0

P-Group: COMMANDS

Active: first confirm

QuickComm.: No

Max: 4000:0

Defines sources of command to start download of parameter set 1 from attached AOP.

Index:

P0801[0] : 1st. Command data set (CDS)
P0801[1] : 2nd. Command data set (CDS)
P0801[2] : 3rd. Command data set (CDS)

Common Settings:

Note:

See parameter P0800

Level