Siemens 440 - Manual (Page 5)

Issue 01/06 Table of Contents
MICROMASTER 440 Parameter List
6SE6400-5BB00-0BP0
5
Parameters MICROMASTER 440
This Parameter List must only be used together with the Operating Instructions of the
MICROMASTER 440. Please pay special attention to the Warnings, Cautions, Notices
and Notes contained in these manuals.
Table of Contents
1 Block Diagram and Terminals ....................................................................7
1.1 Block Diagram ............................................................................................7
1.2 Power Terminals ........................................................................................8
1.3 Control Terminals .....................................................................................11
2 Parameters...............................................................................................12
2.1 Introduction to MICROMASTER System Parameters..............................12
2.2 Quick commissioning (P0010 = 1) ...........................................................15
2.3 Command and Drive Datasets - Overview...............................................17
2.4 Binector Input Parameters........................................................................21
2.5 Connector Input Parameters ....................................................................22
2.6 Binector Output Parameters.....................................................................22
2.7 Connector Output Parameters .................................................................23
2.8 Connector/Binector Output Parameters ...................................................24
3 Parameter Description..............................................................................25
3.1 Common parameters................................................................................25
3.2 Diagnosis parameters ..............................................................................29
3.3 Inverter parameters (HW).........................................................................42
3.4 Motor parameters .....................................................................................50
3.5 Speed encoder .........................................................................................67
3.6 Application macros ...................................................................................69
3.7 Motor temperature....................................................................................69
3.8 Command source .....................................................................................75
3.9 Digital inputs.............................................................................................77
3.10 Digital outputs...........................................................................................84
3.11 Analog inputs............................................................................................86
3.12 Analog outputs .........................................................................................93
3.13 Parameter / command / drive data set .....................................................97
3.14 BICO command parameters.................................................................. 102
3.15 Communication parameters .................................................................. 105
3.16 Setpoint source ..................................................................................... 110
3.17 Fixed frequencies .................................................................................. 113
3.18 Motorized potentiometer (MOP)............................................................ 120
3.19 JOG ....................................................................................................... 122
3.20 Setpoint channel.................................................................................... 125