FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 62)

XG Series User's Guide Chapter 4 Switch Functions and their Configuration
Basic Switch Functions 62
4.1.2 MAC Address Table Management
The MAC address table is a database used for managing the association between address information and destination ports.
XG0224 and XG2600 can learn up to 16000 entries of MAC addresses.
XG0448 can learn up to 32000 entries of MAC addresses.
• Dynamic MAC address learning
The device dynamically learns MAC addresses from received frames. If MAC addresses are not refreshed before the
aging time expires, they will be removed frame MAC address table.
To disable the dynamic learning, carry out the following procedures in "admin" Operation mode.
To change aging time period of MAC address learning table, carry out the following procedures in "admin" Operation
mode..
• Static unicast address
By registering a unicast MAC address with the MAC address table, unicast frames are forwarded to a specified port.
Static unicast addresses are not subject to MAC address removal controlled by the aging function.
To register, change or delete a static unicast address, carry out the following procedures in "admin" Operation mode.
Command Task
XG2600# configure Switch to Configuration mode.
XG2600(config)# mac learning off Disable the dynamic MAC address learning.
XG2600(config)# commit Apply the configuration.
XG2600(config)# save Save the configuration.
XG2600(config)# exit Switch to Operation mode.
Command Task
XG2600# configure Switch to Configuration mode.
XG2600(config)# mac age 1000 Change aging time period of MAC address learning table.
XG2600(config)# commit Apply the configuration.
XG2600(config)# save Save the configuration.
XG2600(config)# exit Switch to Operation mode.
Command Task
XG2600# configure Switch to Configuration mode.
XG2600(config)# vlan forward Register a static unicast address, destination port and vlan with
the MAC address table (or remove them from it).
XG2600(config)# delete vlan forward
XG2600(config)# commit Apply the configuration.
XG2600(config)# save Save the configuration.
XG2600(config)# exit Switch to Operation mode.