FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 142)

XG Series User's Guide Chapter 5 Command Reference
Port Information Settings 142
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use "resource filter distribution" command and change
resource distribution.
Note 4.
Up to 700 commands can be set for the entire device, including the definitions which refer
to ACL such as
"ether macfilter" , "ether qos aclmap" , "vlan macfilter" , "vlan ip6filter" ,
"vlan qos aclmap" , "vlan ip6qos aclmap" , "lan ip filter" , "lan ip dscp" , "lan ip6 filter" , "lan
ip6 dscp" and "serverinfo filter" commands.
Note 5.
When the port type of the Ethernet port is a link aggregation, set it only to the anchor port
where the link aggregation is composed.
Default It is assumed that this option has not been set.
5.1.6.2 ether qos aclmap move
Function Change the QoS conversion priority of the Ethernet port.
Available Model XG0224 / XG0448 / XG2600
Syntax ether qos aclmap move
Options
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
• Source priority
Set the source priority with a decimal value.
• Destination priority
Set the destination priority with a decimal value.
Use Mode Configuration mode (admin class)
Explanation Change the priority of QoS definition for each Ethernet port.
If the current priority is set as , change the priority of this definition to
.
When the definition is changed, the priority is renumbered.
Default N/A due to an edit command.
Range Model
0 to 511 XG0224 / XG0448
0 to 63 XG2600