FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 308)

XG Series User's Guide Chapter 5 Command Reference
Device Information Settings 308
5.15.8.14 serverinfo sftp ip6
Function Set the IPv6 SSH FTP server function
Available Model XG0224 / XG0448 / XG2600
Syntax serverinfo sftp ip6
Options
• on
Enable IPv6 SSH FTP server function
• off
Disable IPv6 SSH FTP server function
Use Mode Configuration mode (admin class)
Explanation Set whether or not to enable IPv6 SSH FTP server function
Setting this command OFF and the
"serverinfo ssh ip6" command OFF will reject a
connection request using the IPv6 address from the sftp client.
Setting this command OFF and the
"serverinfo ssh ip6" command ON will reject a
connection request using the IPv6 address from the sftp client after the password was
entered.
Caution Enabling this command generates an SSH host authentication key at device power-on or
execution of the
"reset" command, and it takes several tens of seconds to several
minutes for the processing time. sftp connection is enabled after the SSH host
authentication key generation was completed.
If this device has been started to enable this function while all the ssh and sftp functions
were Off, it also takes several tens of seconds to several minutes for the processing time
to generate an SSH host authentication key. Note that other processes may be affected;
session monitoring timeout may occur, for example.
Default It is assumed that the IPv6 SSH FTP server function is enabled.
5.15.8.15 serverinfo telnet
Function Set the TELNET server function.
Available Model XG0224 / XG0448 / XG2600
Syntax serverinfo telnet ip
Options
• on
Enable the TELNET server function.
• off
Disable the TELNET server function.
Use Mode Configuration mode (admin class)
Explanation Set whether or not to enable the TELNET server function.
Default It is assumed that the TELNET server function is enabled.
serverinfo sftp ip6 on
serverinfo telnet ip on