FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 124)

XG Series User's Guide Chapter 5 Command Reference
Port Information Settings 124
5.1.3 STP Information
This section explains about the commands related to STP information.
5.1.3.1 ether stp use
Function Set the STP availability.
Available Model XG0224 / XG0448 / XG2600
Syntax ether stp use
Options
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
• on
Specify it when STP is used.
• off
Specify it when STP is not used.
Use Mode Configuration mode (admin class)
Explanation Set whether or not to enable the STP.
Caution If the STP operation mode of the device is OFF (stp mode disabled), the "stp use on"
setting is ignored and disabled.
If the STP operation mode of the bridge is case except OFF (stp mode disabled), the
communication on the port may temporarily fail by the change of topology.
Set "stp use off" for the port where the STP is not used.
Default It is assumed that the STP is used in the ether port.
ether stp use on